| Speed(MAX) |
Vacuum pack : 10 cycles /min(MAX) |
| Gas pack : 8 cycles /min(MAX) |
| Blister pack : 10 cycles /min |
| Width of base film |
300~420mm |
| Film used |
Lid : Heat sealable oriented plastic films |
| Bottom:Thermo-formable and heat sealable plastic films |
| Maximum:370mm |
| Draw depth |
Side draw: 80mm |
| Products |
Foods in general, general goods, medical tools, industrial products, etc. |
| Main unitTotal Length |
Standard type3,000mm(standard)
Long body4,000mm |
| Forming systems |
Vacuum forming method by Hot Plate |
| Seal method |
Heat sealing method |
| Marking alignment |
The penetration type is usually employed.
(Reflection type is also possible) |
| Film feeding |
Servo motor driven intermittent feeding method |
| Cross-cut system |
Cylinder driven slide-cut method |
| Longitudinal cutting system |
Rotating blade directly driven by motor |
| Film scrap remover |
Vacuum & winder type or cutting type |
| Air |
0.6Mpa/･Approx. 120litere/shot ※(Differs depending on the specification.) |
| Cooling water |
Over 0.2~0.3Mpa･4~5liter/min |
| Power used |
3PH AC200V 12KVA ※(Differs depending on the specification.) |
| Machine weight |
Approx. 1,100kg |
